C9200L-48T-4X-E
Not supported
C9200L-48P-4X-E
PoE/PoE+
Cisco switch comparison
C9200L-48T-4X-E vs C9200L-48P-4X-E
A key difference between Cisco C9200L-48T-4X-E and C9200L-48P-4X-E is PoE Support: C9200L-48T-4X-E — Not supported; C9200L-48P-4X-E — PoE/PoE+. They also differ in PoE Standard (Not applicable vs IEEE 802.3af / 802.3at) and Default PoE Budget (Not applicable vs 740 W). If the switch must power phones, cameras or access points, review the C9200L-48P-4X-E; the listed value for the C9200L-48T-4X-E does not provide that PoE capability. The table below shows 68 specifications available for both models. Confirm licenses, accessories, power supplies and regional suffixes before ordering.
2models compared
68specs shown for every model
11differences found
Change comparison
Select different models
At-a-glance comparison
Key performance and configuration differences
Start with the differences that have the greatest effect on capacity, connectivity, software, power and deployment fit.
C9200L-48T-4X-E
Not applicable
C9200L-48P-4X-E
IEEE 802.3af / 802.3at
C9200L-48T-4X-E
Not applicable
C9200L-48P-4X-E
740 W
C9200L-48T-4X-E
PWR-C5-125WAC
C9200L-48P-4X-E
PWR-C5-1KWAC
C9200L-48T-4X-E
1G RJ-45
C9200L-48P-4X-E
1G PoE+ RJ-45
C9200L-48T-4X-E
0
C9200L-48P-4X-E
48
Buying decision
How to choose between C9200L-48T-4X-E and C9200L-48P-4X-E
Review the differences in this order to identify the model that best fits the intended deployment.
-
01
Ports and uplinks
Match access media, port count and speed first, then confirm that the uplink design fits the distribution layer.
-
02
PoE and power
Total the power required by connected devices and verify the PoE standard, budget, power supplies and redundancy.
-
03
Performance and software
Compare forwarding, stacking and scale in the intended topology, then confirm the license tier and software release.
Before ordering
Confirm the exact Product ID, license tier, power supplies, accessories and regional requirements.
Free product-selection help
Need help deciding between these Cisco models?
Send your port, performance, license, quantity or deployment requirements. A CCIE-level network engineer will review the shortlist and help identify the better-fit Product ID.
Detailed comparison
Full specification comparison
| Comparison parameter | ||
|---|---|---|
| Product ID | C9200L-48T-4X-E | C9200L-48P-4X-E |
| Product and ordering | ||
| Product Type | Cisco Catalyst 9200L Series fixed-uplink stackable access switch | Cisco Catalyst 9200L Series fixed-uplink stackable access switch |
| Form Factor | 1RU | 1RU |
| Switch Role | Campus access switch | Campus access switch |
| Network License | Network Essentials | Network Essentials |
| Configuration, licensing and management | ||
| Management Model | Cisco Catalyst Center, WebUI, CLI, NETCONF, RESTCONF and SNMP | Cisco Catalyst Center, WebUI, CLI, NETCONF, RESTCONF and SNMP |
| Ports and interfaces | ||
| Downlink Port Count | 48 | 48 |
| Access / Downlink Ports | 48 x 1G data RJ-45 | 48 x 1G PoE+ RJ-45 |
| Downlink Type | 1G RJ-45 | 1G PoE+ RJ-45 |
| Uplink Interfaces | 4 x 1/10G SFP+ | 4 x 1/10G SFP+ |
| Maximum Uplink Speed | 10 Gbps | 10 Gbps |
| Supported Network Modules | Not applicable | Not applicable |
| Management Ports | 1 x 10/100/1000BASE-T dedicated management port | 1 x 10/100/1000BASE-T dedicated management port |
| Console Ports | 1 x RJ-45; 1 x USB Mini-B console | 1 x RJ-45; 1 x USB Mini-B console |
| USB Ports | 1 x USB 2.0 Type-A host port | 1 x USB 2.0 Type-A host port |
| PoE-capable Ports | 0 | 48 |
| Connector Types | RJ-45; SFP/SFP+; USB | RJ-45; SFP/SFP+; USB |
| Total System Ports | 52 | 52 |
| Performance and scale | ||
| Switching Capacity (Standalone) | 176 Gbps | 176 Gbps |
| Switching Capacity (Stacked) | 256 Gbps | 256 Gbps |
| Forwarding Rate (Standalone) | 130.95 Mpps | 130.95 Mpps |
| Forwarding Rate (Stacked) | 190 Mpps | 190 Mpps |
| MAC Address Scale | 32,000 | 32,000 |
| IPv4 Route Scale | 14,000 | 14,000 |
| IPv6 Route Scale | 2,000 | 2,000 |
| Multicast Route Scale | 1,000 | 1,000 |
| VLAN Scale | 4,094 | 4,094 |
| ACL Scale | 1,600 | 1,600 |
| QoS Scale | 1,000 | 1,000 |
| Packet Buffer | 6 MB | 6 MB |
| Jumbo Frame Size | 9,198 bytes | 9,198 bytes |
| Flexible NetFlow Entries | 16,000 | 16,000 |
| Switched Virtual Interfaces | 512 | 512 |
| PoE and power | ||
| PoE Support | Not supported | PoE/PoE+ |
| PoE Standard | Not applicable | IEEE 802.3af / 802.3at |
| Default PoE Budget | Not applicable | 740 W |
| Maximum PoE Budget | Not applicable | 1,440 W |
| Default Power Supply | PWR-C5-125WAC | PWR-C5-1KWAC |
| Power Supply Slots | 2 | 2 |
| Power Supply Options | Compatible C5/C6 AC supplies; supported DC supply on PoE models | Compatible C5/C6 AC supplies; supported DC supply on PoE models |
| Maximum System Power | 53.67 W | 68.36 W |
| AC Input Voltage | 100 to 240 V | 100 to 240 V |
| AC Input Frequency | 50 to 60 Hz | 50 to 60 Hz |
| Power Input Type | AC input; optional DC power supplies on supported modular and fixed-uplink PoE models | AC input; optional DC power supplies on supported modular and fixed-uplink PoE models |
| Heat Dissipation | 183 BTU/h | 233 BTU/h |
| Power Redundancy | Redundant power with an optional second compatible supply | Redundant power with an optional second compatible supply |
| Stacking and resiliency | ||
| Stacking Technology | StackWise-80 | StackWise-80 |
| Stack Bandwidth | 80 Gbps | 80 Gbps |
| Maximum Stack Members | 8 | 8 |
| StackPower | Not applicable | Not applicable |
| Fan Modules | Fixed redundant fans | Fixed redundant fans |
| Memory and software | ||
| Operating System | Cisco IOS XE | Cisco IOS XE |
| Minimum Software Release | Cisco IOS XE 16.9.2 | Cisco IOS XE 16.9.2 |
| DRAM | 2 GB | 2 GB |
| Flash Memory | 4 GB | 4 GB |
| Physical and environmental | ||
| Dimensions (H × W × D) | 44 × 445 × 329 mm | 44 × 445 × 329 mm |
| Weight | 4.53 kg | 4.8 kg |
| Operating Temperature | -5 to 45 °C; -5 to 40 °C | -5 to 45 °C; -5 to 40 °C |
| Storage Temperature | -40 to 70 °C | -40 to 70 °C |
| Operating Humidity | 5% to 90% | 5% to 90% |
| Operating Altitude | Up to 3,048 m | Up to 3,048 m |
| MTBF | 503,400 hours | 346,270 hours |
| Warranty | Cisco Enhanced Limited Lifetime hardware warranty (E-LLW) | Cisco Enhanced Limited Lifetime hardware warranty (E-LLW) |
| Acoustic Rating | 42 dBA typical; 45 dBA maximum | 42 dBA typical; 45 dBA maximum |
| Environmental Compliance | RoHS compliant | RoHS compliant |
| Safety Certifications | UL/CSA 60950-1; EN/IEC 60950-1 | UL/CSA 60950-1; EN/IEC 60950-1 |
| EMC Certifications | FCC Part 15 Class A; EN 55032 Class A; CISPR 32 Class A; ICES-003 Class A | FCC Part 15 Class A; EN 55032 Class A; CISPR 32 Class A; ICES-003 Class A |
| Mounting | 19-inch rack mount | 19-inch rack mount |
| Airflow | Front-to-back airflow | Front-to-back airflow |
“Not listed” means that no confirmed value is currently available for that model and parameter.
Price, stock & lead time
Get pricing for the exact models you compared
Use the exact Product ID when requesting a quote, because suffixes can identify different licenses, regions or configurations. Open an available product page for details and pricing, or request a project quote from our team.
Browse all Cisco switchesRelated comparisons
More Cisco switch comparisons
Catalyst 9200 Switches
C9200L-48P-4G-EVSC9200L-48P-4X-E
Compare C9200L-48P-4G-E vs C9200L-48P-4X-E
Catalyst 9200 Switches
C9200L-48P-4X-EVSWS-C2960X-48FPD-L
Compare C9200L-48P-4X-E vs WS-C2960X-48FPD-L
Catalyst 9200 Switches
C9200L-48P-4X-EVSWS-C2960X-48LPD-L
Compare C9200L-48P-4X-E vs WS-C2960X-48LPD-L
View all popular Cisco Switch Comparisons →